Relocatable Commercial/Industrial Structures

All markings must be permanent and visible after installation. 

One of the following specification nameplates (as applicable):

1.   Commercial/Industrial Unit for Electrical Features Only - Specification Nameplate (Item 1079) – Province of Manitoba and/or Saskatchewan

Black Lettering on White Background

Size: 8 ½ inches by 11 inches. 

The specification nameplate is located in close proximity to the electrical panel board and includes:

-          Manufacturer’s name and address

-          Model and serial number

-          Date of manufacture

-          Complete electrical rating

-          A list of appliances that are factory installed

-          Additional markings as may be required

2.   (Item 1061) – Province of Alberta, Manitoba,and/or Saskatchewan

Black Lettering on White Background

Size: 8 ½ inches by 11 inches. 

The specification nameplate is located in close proximity to the electrical panel board and includes:

-          Manufacturer’s name and address

-          Model and serial number

-          Date of manufacture

-          Fuel type

-          Complete electrical rating

-          A list of appliances that are factory installed

-          Ground snow load and roof design snow load

-          Thermal resistance of insulation and the outside design temperature used in heat-loss calculations

-          The building codes met by the building

-          Additional markings as may be required

One of the following set of labels (as applicable):

1.   QAI label with 'c' identifier (Item 1069) –Commercial/Industrial Unit for Electrical  Features Only (Province of Manitoba and/or Saskatchewan)

Black Lettering with Silver Background

The QAI label is usually located in close proximity to the electrical panel board. 

 

2.   QAI label with ‘c’ identifier (Item 1095) – Relocatable Commercial/Industrial  Structures (Province of Manitoba and/or Saskatchewan)

Black Lettering with Silver Background

The QAI label is usually located in close proximity to the electrical panel board. 

 

3.   QAI label with ‘c’ identifier (Item 1093) – Relocatable  Commercial/Industrial   Structures  Plumbing and Gas (Alberta Part 10 Program)

Black Lettering with Silver Background

The QAI label is usually located in close proximity to the electrical panel board.

4. QAI label with ‘c’ identifier (Item 1094) – Relocatable Commercial/Industrial Structures – Electrical (Alberta Part 10 Program)

Black Lettering with Silver Background

The QAI label is usually located in close proximity to the electrical panel board.

The QAI labels and specification nameplates are available only from QAI and must be applied at the factory. 

The scope of structures covered by this listing includes:

Buildings are:              Commercial/Industrial structures comprised of single or multiple modules. Group C, D, and E occupancy, in single storey configuration and without sprinkler systems. Buildings with sleeping accommodations have a building area not exceeding 600m². Buildings without sleeping accommodations have a building area not exceed 1200m². Commercial/Industrial structures typically include but are not limited to office space, stores, construction camp facilities such as dormitories and dining trailers, equipment buildings, and other similar commercial or industrial buildings. 

Structural:                  Conventional wood frame construction

Electrical Rating:         120/240 VAC, 60Hz, 200A max

Heating:                     Central Forced Air Furnaces. Units may be Electric, Natural Gas, or LPG fired. Systems may be equipped with air conditioning.

Plumbing:                   Conventional drainage and vent systems to a maximum of 240 hydraulic fixture units. 

This listing does not include buildings for use in hazardous locations.  This listing does not include vehicular lighting or brake wiring systems. 

Structures included in this listing are relocatable commercial/industrial structures manufactured at a central facility, complete with electrical wiring, for installation or connection to other modules in the field. These units, when completely assembled on site, are equipped with normal facilities for connection to electrical services.  QAI certification covers the construction of the structure and any factory installed electrical services, and is intended to obviate the necessity of further inspection by the local regulatory authorities except for site connections to services or to other modules and for site mounting features.