CSA A277-16 “Procedure for Certification of Prefabricated Buildings, Modules, and Panels”
National Building Code of Canada, Part 9
Quebec Construction Code, Chapter I – Building (NBC with Quebec amendments), Part 9
CSA C22.1 “Canadian Electrical Code, Part I, “Safety Standard for Electrical Installations”
CSA C22.10 Quebec Construction Code, Chapter V – Electricity (Canadian Electrical Code, Part I, “Safety Standard for Electrical Installations” with Quebec amendments)
National Plumbing Code of Canada

Note 1: Unless otherwise specified, the Standards and Codes noted are the most current versions in effect.

Note 2: Various provinces and territories have amendments to the national building code, jurisdictions may require structures to comply with provincial/municipal codes in lieu of the national building codes, the local AHJ should be consulted on the applicable requirements.

Business Commercial Industrial Structures

All markings must be permanent and visible after installation.
1. The QAI label (item 1096 – black lettering with silver background) is normally located in close proximity to the electrical panel.

QAI logo shown here:

2. The specification nameplate (item 1068, 8-1/2” x 14” size) is located in close proximity to the electrical panel and includes:
− Manufacturer’s Name and Address
− Date of Manufacture
− Model Serial Number or Product Code
− Foundation Type (Perimeter Foundation Wall or Piers)
− Floor live Load
− Specified Snow Load (1/50)
− Seismic Response Sa (0.2)
− Hourly Wind Pressure (1/50)
− Envelope Effective Thermal Resistance
− Windows/Doors/Skylights Thermal Characteristics
− Outside Design Temperature (Heal Loss or Heat Gain)
− Factory Installed Appliances
− Site Installed Components, Assemblies, and Systems
− Electrical Systems Voltage, Frequency, and Amperage

3. Other Markings as required by the relevant codes.

Note 3: The QAI label and specification nameplate are available from QAI and must be applied at the factory.

Structures are used for single Major Occupancy classified as Group D – Business and Personal Services occupancies, constructed in single or multiple modules in single storey configurations not exceeding 600m². Units classified under this occupancy are not intended for general public access.

Structures under this listing typically include units used as business offices or for personal services. This listing does not include structures with multiple Major Occupancies.

For a full list of structures covered under the above Occupancy Class, please refer to Division B, Notes to Part 3, A-3.1.2.1.(1) Major Occupancy Classification in the National Building Code of Canada.”

Structural:
Conventional Wood Frame Construction within the limitations of Part 9 of the National Building Code and Quebec Construction Code, Chapter I – Building.

Electrical Ratings:
120/240V, 60Hz, 200A Max.

Heating/Ventilation:
Electric Baseboard Heaters. Modules may be equipped with ventilation system and air conditioning (electric only).

Plumbing:
Conventional drainage and venting systems to a maximum of 240 hydraulic fixture units.

Gas Systems:
None.