CSA A277-16 “Procedure for certification of prefabricated buildings, modules, and panels”,
CSA Z240MH-Series 16 “Manufactured Homes”
National Building Code of Canada (Part 9),
National Plumbing Code of Canada,
CSA C22.1 Canadian Electrical Code, Part 1

Factory Built Manufactured Homes

Products are marked in a permanent manner where it is readily visible
after installation with the following:
1. The QAI label (item 1064) is normally located in close proximity to
the electrical panel and includes:
 Certification Label Serial Number
 QAI certification label with the ‘c’ identifier,
 QAI Logo is shown here:

2. The Specification Nameplate (item 1072, 8-1/2” x 14”) is located in
close proximity to the electrical panel and includes:
 Manufacturer’s Name and Address,
 Date of Manufacture,
 Product Serial Number or Product Code,
 Foundation Type,
 Floor Live Load,
 Specified Snow Load (1/50),
 Seismic Response Sa (0.2),
 Hourly Wind Pressure (1/50),
 Building Envelope Effective Thermal Resistance,
 Windows/Doors/Skylights Thermal Characteristics,
 Outside Design Temperature (Heat Loss/Heat Gain),
 Factory Installed Appliances,
 Site Installed Components, Assemblies, and Systems, and
 Electrical System Voltage, Frequency, and Amperage
 Other markings as required by the relevant codes

Other Markings as required by the Relevant Codes.

Note: the QAI Label and Specification Nameplate are available from QAI and must be applied at the Factory.

Manufactured homes comprised of single modules in single storey
configurations.

Structural:
Conventional Wood Frame construction.

Electrical:
120/240V, 1PH, 60Hz, 200A

Heating/Ventilation:
Electric baseboard heaters. Systems may be equipped with air
conditioning units.

Plumbing:
Conventional drainage and venting systems to a maximum of 240
hydraulic fixture units.

Gas:
None.