CSA A277-16 “Procedure for certification of prefabricated buildings, modules, and panels”,
British Columbia Building Code, Parts 3,4,5, and 6,
Alberta Building Code, Parts 3,4,5, and 6,
National Building Code of Canada, Parts 3,4,5, and 6,
National Plumbing Code of Canada,
British Columbia Plumbing Code,
CSA C22.1 Canadian Electrical Code (Part 1)

Note: Unless otherwise specified, the Standards/Codes noted are the most current versions in effect.

Factory Built Permanent Engineered Structures

All markings must be permanent and visible after installation.

1. QAI label with ‘C’ identifier (item 1097) – black lettering with silver background) is normally located in close proximity to the electrical panel.
QAI logo shown here:

2. The specification nameplate (item 1068, 8-1/2” x 14” in size) is normally located in close proximity to the electrical panel and includes:
− Manufacturer’s Name and Address
− Date of Manufacture
− Model Serial Number or Product Code
− Foundation Type (Perimeter Foundation Wall or Piers)
− Floor live Load

− Specified Snow Load (1/50)
− Seismic Response Sa (0.2)
− Hourly Wind Pressure (1/50)
− Envelope Effective Thermal Resistance
− Windows/Doors/Skylights Thermal Characteristics
− Outside Design Temperature (Heal Loss or Heat Gain)
− Factory Installed Appliances
− Site Installed Components, Assemblies, and Systems
− Electrical Systems Voltage, Frequency, and Amperage

3. Other Markings as required by the relevant codes.

The QAI Label and Specification Nameplate are available from QAI and must be applied at the Factory.

Factory Built Permanent Engineered Structures built under Parts 3,4,5, and 6 of the BC Building Code, Alberta Building Code and National Building Code of Canada. These structures are intended to be used for a single Major Occupancy classified as Group C, Residential.

For a full list of structures covered under the above Occupancy Class, please refer to Division B, Notes to Part 3, A-3.1.2.1.(1) Major Occupancy Classification in the National Building Code of Canada.

The design of each discipline: structural, electrical, architectural, mechanical, and electrical require review and approval by Registered Professionals registered in the Province where the units are intended to be installed.

Structural:
Conventional Wood Frame construction designed in Part 4 by Professional Engineer

Electrical Ratings:
120/208V, 60Hz, 400A maximum

Heating/Ventilation:
Suites may be equipped with electric baseboard heaters and Packaged Terminal Air Conditioners (PTAC).

Plumbing:
Conventional drainage and vent systems to a maximum of 240 hydraulic fixture units.

Sprinkler and Fire Alarm Systems:

This certification covers factory installed portions of the fire alarm and sprinkler systems. The design of the fire alarm and sprinkler system must be designed by a professional engineer registered in the province in which the building is installed. Installation and commissioning of the fire alarm and sprinkler system must be completed on site by qualified technicians as per the requirement of the Authority Having Jurisdiction.

Gas Systems:
None.