CSA A277 “Procedure for Certification of Prefabricated Buildings, Modules, and Panels

CSA C22.1-15 “Canadian Electrical Safety Code, Part 1,  (23rd Edition) Safety Standard for Electrical Installations”

Ontario Electrical Safety Code, 2015 Part 1, (26th Edition)

Ontario Building Code Part 9

Ontario Plumbing Code

National Building Code Part 9

National Plumbing Code

Note: Unless otherwise specified, the standards/Code noted are the most current versions in effect.

Business Commercial Industrial Structures

All markings must be permanent and visible after installation.
The QAI label (item 1096) is normally located in close proximity to the
electrical panel.
The specification nameplate (item 1098, white with black, 8-1/2” x 14”) is
located in close proximity to the electrical panel and includes:

 Manufacturer’s Name and Address
 Date of Manufacture
 Model Serial Number or Product Code
 Foundation Type (Perimeter Foundation Wall or Piers)
 Floor live Load
 Specified Snow Load (1/50)
 Seismic Response Sa(0.2)
 Hourly Wind Pressure (1/50)
 Envelope Effective Thermal Resistance
 Windows/Doors/Skylights Thermal Characteristics
 Outside Design Temperature (Heal Loss or Heat Gain)
 Factory Installed Appliances
 Site Installed Components, Assemblies, and Systems
 Electrical Systems Voltage, Frequency, and Amperage

Occupancy:
Structures are used for single Major Occupancy classified under Group D
– Business and Personal Services occupancies, constructed in single or
multiple modules up to 2-storey configurations. These structures do not
exceed a building area of 600m2.
Structures under this listing typically include units used as business
offices or for personal services. For a full list of structures covered under
this occupancy please refer to Appendix A, Division B of the Ontario
Building Code. This listing does not include Buildings with multiple Major
Occupancies.
Structural:
Conventional Wood Frame Construction within the limitations of Part 9 of
the Ontario Building Code.
Electrical Ratings:
120/240V, 60Hz, 200A max.

Heating/Ventilation:
Central forced air furnace, electrical baseboard heaters, or hot water
hydronic units. Units maybe electric, natural gas, or propane fired.
Modules may be equipped with ducting for installation of a central forced
air furnace on site.
Plumbing:
Conventional drainage and venting systems to a maximum of 240
hydraulic fixture units.
Gas Systems:
None.