CSA A277 “Procedure for Factory Certification of Prefabricated Buildings, Modules, and Panels”
Quebec Construction Code, Chapter I – Building (NBC with Quebec amendments) – Part 9
CSA C22.10 Quebec Construction Code, Chapter V – Electricity (CSA C22.1 CEC, Part I, with Quebec amendments)
National Plumbing Code of Canada 2010
Ontario Building Code – Part 9 Housing and Small Buildings
Ontario Building Code – Part 7 Plumbing
Ontario Electrical Safety Code (CSA C22.1 CEC, Part I, with Ontario amendments)
National Building Code of Canada 2010 – Part 9
CSA C22.1-12 Canadian Electrical Code, Part I (22nd Edition) “Safety Standard for Electrical Installations”
Alberta Building Code 2006 – Part 9
British Columbia Building Code 2012 – Part 9
British Columbia Plumbing Code 2012
CSA B149.1-10 “Natural Gas and Propane Installation Code”

Note 1: Unless otherwise specified, the Standards and Codes noted are the most current versions in effect.

Modular Homes

All markings must be permanent and visible after installation.

1. The QAI label (item 1067, black with gold, 3-1/2” diameter) is normally located in close proximity to the electrical panel and includes:
− Certification label serial number:

− QAI certification logo with the “C” Identifier
− “Modular Homes”

QAI logo shown here:

2. The specification nameplate (item 1068, 8-1/2” x 14” size) is located in close proximity to the electrical panel and includes:
− Manufacturer’s Name and Address
− Date of Manufacture
− Model Serial Number or Product Code
− Foundation Type (Perimeter Foundation Wall or Piers)
− Floor live Load
− Specified Snow Load (1/50)
− Seismic Response Sa (0.2)
− Hourly Wind Pressure (1/50)
− Envelope Effective Thermal Resistance
− Windows/Doors/Skylights Thermal Characteristics
− Outside Design Temperature (Heal Loss or Heat Gain)
− Factory Installed Appliances
− Site Installed Components, Assemblies, and Systems
− Electrical Systems Voltage, Frequency, and Amperage

3. Other Markings as required by the relevant codes.

Note 2: The QAI label and specification nameplate are available from QAI and must be applied at the factory.

Single or multiple family dwellings classified under one major occupancy (Group C – Residential), constructed in single or multiple modules up to a maximum of 3 storey configurations. Modular homes under this scope have a building area not exceeding 600m².

Multi-residential buildings are designed and constructed within the limitations of Part 9 of the building code with vertical fire and sound separations. This listing does not include hotels and motels, and/or any buildings designed with multiple major occupancies.

For a full list of structures covered under this occupancy please refer to Notes to Part 3, A-3.1.2.1.(1) Major Occupancy Classification in the QCC, OBC, ABC, BCBC and/or NBC.

Structural:
Conventional Wood Frame Construction within the limitations of Part 9 of the QCC, OBC, ABC, BCBC and/or NBC.

Electrical Ratings: 120/240V, 60Hz, 400A Max.

Heating/Ventilation: Primarily Electric Baseboard Heaters. Modules may be equipped with ducting for installation of a central forced air furnace and air conditioning on site.

Plumbing:
Conventional drainage and venting systems to a maximum of 240 hydraulic fixture units.

Gas Systems:
Modules may be equipped with gas or propane appliances and equipment.