CSA A277 “Procedure for Certification of Prefabricated Buildings, Modules, and Panels”

Quebec Construction Code, Chapter I – Building (NBC with Quebec amendments), Part 9

National Building Code of Canada, Part 9

CSA C22.10 Quebec Construction Code, Chapter V – Electricity (CSA C22.1 Canadian Electrical Code, Part I, “Safety Standard for Electrical Installations” with Quebec amendments)

CSA C22.1 Canadian Electrical Code, Part I, “Safety Standard for Electrical Installations”

National Plumbing Code of Canada

Note 1: Unless otherwise specified, the Standards/Codes noted are the most current versions in effect.

Note 2: Various provinces and territories have amendments to the national building code, jurisdictions may require structures to comply with provincial/municipal codes in lieu of the national building codes, the local AHJ should be consulted on the applicable requirements.

Modular Homes

All markings must be permanent and visible after installation.
1. The QAI label (item 1067, black with gold, 3-1/2” diameter) is normally located in close proximity to the electrical panel and includes:
− Certification label serial number
− QAI certification logo with the “C” Identifier
− “Modular Homes”
QAI logo shown here:

proximity to the electrical panel and includes:
− Manufacturer’s Name and Address
− Date of Manufacture
− Model Serial Number or Product Code
− Foundation Type (Perimeter Foundation Wall or Piers)
− Floor live Load
− Specified Snow Load (1/50)
− Seismic Response Sa (0.2)
− Hourly Wind Pressure (1/50)
− Envelope Effective Thermal Resistance
− Windows/Doors/Skylights Thermal Characteristics
− Outside Design Temperature (Heal Loss or Heat Gain)
− Factory Installed Appliances
− Site Installed Components, Assemblies, and Systems
− Electrical Systems Voltage, Frequency, and Amperage

3. Other Markings as required by the relevant codes.

Note: The QAI label and specification nameplate are available from QAI and must be applied at the factory.

Single or multi-family dwellings classified under one major occupancy (Group C – Residential), constructed in single or multiple modules up to a maximum of 3 storey configurations. Modular homes under this scope have a building area not exceeding 600m2.

Multi residential buildings are designed and constructed within the limitations of Part 9 with vertical fire and sound separations. This listing does not include multi-residential buildings requiring horizontal fire and sound separation or shared egress facilities, hotels and motels, and/or any buildings designed with multiple major occupancies.

For a full list of structures covered under this occupancy please refer to Notes to Part 3, A-3.1.2.1.(1) Major Occupancy Classification in the Quebec Construction Code, Chapter I – Building and National Building Code.

Structural:
Conventional Wood Frame Construction within the limitations of Part 9 the Quebec Construction Code, Chapter I – Building and National Building Code.

Electrical Ratings:
120/240V, 60Hz, 200A Max.

Heating/Ventilation:
Electric Baseboard Heaters. Modules may be equipped with central forced-air furnace and air conditioning.

Plumbing:
Conventional drainage and venting systems to a maximum of 240 hydraulic fixture units.

Gas Systems:
None

Notes:
Modular Homes included in this listing are manufactured at a central facility and transported to the site. These modules must include provisions for on-site interconnections, connection to municipal services (water and sewage) and electrical power supply. QAI certification covers the construction of the modular homes including any factory installed plumbing and electrical services, appliances, equipment and fixtures. QAI certification is intended to obviate the necessity of further inspection by the local regulatory authorities except for site connections to services or to other modules and for site installed features.
Site installation of products must be done according to manufacturer’s installation instructions and in compliance with the requirements set by the local authority having jurisdiction.