CSA A277 “Procedure for Factory Certification of Prefabricated Buildings, Modules, and Panels”

Quebec Construction Code, Chapter I – Building (NBC with Quebec amendments), Part 9

CSA C22.10 Québec Construction Code, Chapter V – Electricity (Canadian Electrical Code, Part I, “Safety Standard for Electrical Installations” with Quebec amendments)

National Plumbing Code of Canada

Ontario Building Code, Part 9 and Part 7 Plumbing

Ontario Electrical Safety Code

Note: Unless otherwise specified, the Standards/Codes noted are the most current
versions in effect.

Modular Homes

All markings must be permanent and visible after installation.
1. The QAI label (item 1067, black with gold, 3-1/2” diameter) is normally located
in close proximity to the electrical panel and includes:
− Certification label serial number
− QAI certification logo with the “C” Identifier
− “Modular Homes”

QAI logo shown here:

2. The specification nameplate (item 1068, 8-1/2” x 14” size) is located in close
proximity to the electrical panel and includes:
− Manufacturer’s Name and Address
− Date of Manufacture
− Model Serial Number or Product Code
− Foundation Type (Perimeter Foundation Wall or Piers)
− Floor live Load
− Specified Snow Load (1/50)
− Seismic Response Sa (0.2)
− Hourly Wind Pressure (1/50)
− Envelope Effective Thermal Resistance
− Windows/Doors/Skylights Thermal Characteristics
− Outside Design Temperature (Heal Loss or Heat Gain)
− Factory Installed Appliances
− Site Installed Components, Assemblies, and Systems
− Electrical Systems Voltage, Frequency, and Amperage

Other Markings as required by the relevant codes.

Note: The QAI label and specification nameplate are available from QAI and must
be applied at the factory.

Single or multi-family dwellings classified under one major occupancy (Group C –Residential), constructed in single or multiple modules up to a maximum of 2 storey configurations. Modular homes under this scope have a building area not
exceeding 600m².

Multi residential buildings are designed and constructed within the limitations of Part 9 with vertical fire and sound separations. This listing does not include multi-residential buildings requiring horizontal fire and sound separation or shared
egress facilities, hotels and motels, and/or any buildings designed with multiple major occupancies.

For a full list of structures covered under Group C occupancy, please refer to Appendix A, Division B of the National Building Code.

Structural:
Conventional Wood Frame Construction within the limitations of Part 9 of the Ontario Building Code and Quebec Construction Code, Chapter I – Building.

Electrical Ratings:
120/240V, 60Hz, 200A Max.

Heating/Ventilation:
Primarily Electric Baseboard Heaters. Modules may be equipped with ducting for installation of a central forced air furnace on site. Modular homes may be equipped with air conditioning (electric only).

Plumbing:
Conventional drainage and venting systems to a maximum of 240 hydraulic fixture units.

Gas Systems:
None.

Notes:

Modular Homes included in this listing are manufactured at a central facility and transported to the site. These modules must include provisions for on site interconnections, connection to municipal services (water and sewage) and electrical power supply. QAI certification covers the construction of the modular homes including any factory installed plumbing and electrical services, appliances, equipment and fixtures. QAI certification is intended to obviate the necessity of further inspection by the local regulatory authorities except for site connections to services or to other modules and for site installed features.

Site installation of products must be done according to manufacturer’s installation instructions and in compliance with the requirements set by the local authority having jurisdiction.