CSA Z240MH Series-09 (R2005) “Manufactured Homes”

CSA A277-08  “Procedure for Certification of Factory-Built Houses ”With reference to:
National Building Code of Canada (Part 9)

CSA C22.1-12  “Canadian Electrical Code, Part 1, Safety Standard for Electrical
Installations”

National Building Code 2010

National Plumbing Code 2010

Note: Unless otherwise specified, the standards/Code noted are the most current versions in effect.

Manufactured Homes

All markings must be permanent and visible after installation.
The QAI label (item 1064, white lettering on blue background, 3-1/2” diameter) for
single section homes is normally located in close proximity to the electrical panel or
next to the main entrance way of the unit.
The QAI label (item 1065, white lettering on green background, 3-1/2″ diameter)
for multiple section homes is normally located in close proximity to the electrical
panel or next to the main entrance way of the unit.
The specification nameplate (item 1063, black lettering on white background, 8-
1/2” x 11”) is located on the inside of a kitchen cabinet door or the master
bedroom closet and includes:

 manufacturer’s name and address
 model
 serial number
 year of manufacture
 ground snow load and roof design snow load
 design wind pressures in kilopascals (1/50) without anchorage (see Clause
5.4 of CSA Z240.2.1)
 thermal resistance of insulation and the outside design temperature used
in the heat loss calculations
 a list of the appliances that are factory installed in the unit, or supplied
with the unit for installation at the
 site, specifying make, model, and type of energy used (i.e. oil, gas, electricity, or wood)
 complete electrical rating (i.e. voltage, frequency, and input current)
The QAI label and specification nameplate are available from QAI and must be
applied at the factory.

The scope of homes covered in this listing include:
Homes:
Single family dwellings, comprised of single wide or double wide in single storey
configurations

Structural:
Conventional Wood Frame Construction built on steel chassis

Electrical Ratings:
120/240V, 60Hz, 200A Max.

Heating/Ventilation:
Electric Baseboard Heaters. Modules may be equipped with ducting for installation
of a central forced air furnace on site. Manufactured homes may be equipped with
air conditioning (electric only).

Plumbing:
Conventional drainage and venting systems to a maximum of 180 hydraulic fixture
units.

Gas Systems:
None.